SERIES 1 Twin Track Cantilever Mast (115mm Arm) OHLE Kit - OO Gauge (SET E2-2)

Detailed Overhead Line Equipment Mast Structure Kit - SERIES 1 Twin Track Cantilever type with 115mm Arm, including Magnetic Base

PLEASE READ THE FULL PRODUCT DESCRIPTION BELOW

OO Gauge SET E2-2 - product code 4WH0900202

This set E2-2 includes parts to construct One (1) basic SERIES 1 Twin Track Cantilever Mast structure. 

One Pile Driven style Base is included in the kit, with two magnets to fit into the base and OHLE structure. The use of magnets allows the OHLE structures to be easily removed and re-fitted on your layout.

PLEASE NOTE - the registration arms are NOT included and should be purchased separately.

Registration Arm options for the SERIES 1 Twin Track Cantilever type OHLE are available to Purchase Separately as follows:-

• SET E2-9 Left Hand Registration Arm (Series 1)
  
  
• SET E2-10 Right Hand Registration Arm (Series 1)
  
  
• SET E2-11 Combined Left & Right Hand Registration Arms (Series 1)
  
  
• SET E2-12 Left Hand Registration Arm (SERIES 1 magnetic type to allow fitting of Peco type OHL wires) note [wires are not included]
  
  
• SET E2-13 Right Hand Registration Arm (SERIES 1 magnetic type to allow fitting of Peco type OHL wires) note [wires are not included]
  
  
• SET E2-14 Combined Left & Right Hand Registration Arms (SERIES 1 magnetic type to allow fitting of Peco type OHL wires) note [wires are not included]
  
  

All parts are supplied unpainted; before painting it is recommended to apply a light coat of primer.

Regarding the spacing of OHLE masts, the real railway mast spacing can be vary between about 20metres and 70metres which equates to 260 to 920mm in OO Gauge. In general mast spacing is likely to be closer together at junctions and on sharper curves.
The Peco wires are available in the following lengths 200mm, 260mm, 340mm, 380mm and 500mm, so if you are fitting wires then it makes sense to space your masts to suit the Peco wire lengths. [wires are not included in this kit]

OHLE Structure kit (SET E2-2) dimensions:-

• Maximum height above baseboard (including base) - 121mm
• Overall length of structure (across the tracks) - 115mm
• Max width of structure - 11.6mm
• Nominal height of contact wire (if fitted to Magnetic Registration Arms) - 78mm above baseboard [wires not included]

Please see the downloadable "OHLE Equipment Product Guide" in the Attachments TAB above.