N-Gauge OHLE - SERIES 2 - Two Track Cantilever Mast (59mm Arm) Kit - (SET E10-1)

Detailed N-Gauge Overhead Line Equipment Mast Structure Kit - SERIES 2 - Two Track Cantilever type with 59mm Arm, including Magnetic Base
9
PLEASE READ THE FULL PRODUCT DESCRIPTION BELOW

N Gauge SET E10-1 - product code 2WH0901001

This set E10-1 includes parts to construct one (1) basic SERIES 2 - Two Track Cantilever Mast structure. 

One Pile Driven style Base is included in the kit, with magnets to fit into the base and OHLE structure. The use of magnets allows the OHLE structures to be easily removed and re-fitted on your layout.

PLEASE NOTE - the registration arms are NOT included and should be purchased separately.

N-Gauge Registration Arm options for the SERIES 2 - Two Track Cantilever type OHLE are available to Purchase Separately as follows:-

• SET E10-3 Left Hand Registration Arm (Series 2)
  
  
• SET E10-4 Right Hand Registration Arm (Series 2)
  
  
• SET E10-5 Left Hand Registration Arm (SERIES 2 magnetic type to allow fitting of Sommerfeldt type OHL wires) note [wires are not included]
  
  
• SET E10-6 Right Hand Registration Arm (SERIES 2 magnetic type to allow fitting of Sommerfeldt type OHL wires) note [wires are not included]
  
  

All parts are supplied unpainted; before painting it is recommended to apply a light coat of primer.

Regarding the spacing of OHLE masts, the real railway mast spacing can be vary between about 20metres and 70metres which equates to 130 to 470mm in N Gauge. In general mast spacing is likely to be closer together at junctions and on sharper curves.

OHLE Structure kit (SET E10-1) dimensions:-

• Maximum height above baseboard (including base) - 69mm
• Overall length of structure (across the tracks) - 59mm
• Max width of structure/base - 8mm
• Nominal height of contact wire (if fitted to Magnetic Registration Arms) - 43mm above baseboard [wires not included]

Please see the downloadable "OHLE Equipment Product Guide" in the Attachments TAB above.